Filter
Top Products
11 - 3
11. PARAMETERS
Parameter
No.
Symbol Name
Initial
Value
Units
Setting
range
Function
000F *IFM0 Interface mode option 0000h 0000h
to 0F0Fh
00
Interrupt output cycle
When interrupt by interface mode
is valid, set the cycle for which
the interrupt is output.
Interrupt output cycle:
Control cycle (setting value+1)
Example: When interrupt output cycle
is set to 1 and control cycle
is 0.88ms, interrupt is output
approximately every 1.77ms.
Command data update cycle
Set the cycle for which position
command is updated in interface mode.
Command data update cycle:
Control cycle (setting value+1)
Example: When command data update
cycle is set to 2 and control
cycle is 0.88ms, position
command is updated
approximately every 2.66ms.
0010 For manufacturer setting 0
: :
003F 0
0040 LGS1 Log acquiring selection 1
(Note)
0000h
0000h
to 0001h
Set whether to acquire the log of the system when
the log function is used.
System (bit 0)
0: Not acquire 1: Acquire
0041 LGS2 Log acquiring selection 2
(Note)
0000h 0000h
to FFFFh
Set the axis number for which the log is to be
acquired.
Axis 1 (bit 0) to axis 16 (bit 15)
0: Not acquire 1: Acquire
0042 LGS3 Log acquiring selection 3
(Note)
0000h
0000h
to FFFFh
Set the axis number for which the log is to be
acquired.
Axis 17 (bit 0) to axis 32 (bit 15)
0: Not acquire 1: Acquire
0043 For manufacturer setting 0000h
0044 0000h
0045 0
: :
007F 0
Note. When all the system parameters of the log acquiring selection (parameters No. 0040 to 0043) are set to 0000h (initial value), log
for all axes and systems will be acquired.