Filter
Top Products
48 LogTag Analyzer
Getting results from
LogTag
You can retrieve the recordings from LogTag(s) as many times as you require. The
process of retrieving data stored within a LogTag does not erase it from the LogTag's
memory. If the LogTag is currently recording while you retrieve the information, it will
continue to record without interruption.
There are three ways to retrieve the recorded results from a LogTag.
1 While the LogTag Analyzer software is open (does not need to be the currently active
software), simply slot the LogTag into the Interface Cradle. If the automatic download
feature is enabled, the software will automatically retrieve the recorded readings, save
the information to your disk drive and display the information to you. While the
software is automatically retrieving the readings you will see an animated picture
appear, similar to the following picture.
2 Click the "Download..." menu item located in the LogTag menu.
This is the second quickest option, as it does not include the steps involved in
preparing the LogTag(s) for their next use.
3 Click the LogTag icon (
) or the "Wizard..." menu item located in the LogTag menu.
This option will allow you to prepare the LogTag for its next use after retrieving the
readings stored within the LogTag. If you do not need to configure the LogTag for its
next use now, the previous option described may be preferred as it will not involve the
configuration steps and therefore be a quicker and simpler method.