Filter
Top Products
30 LogTag Analyzer
Starting and using the
LogTag
Once a LogTag has been successfully configured for use it is ready to be started. To start
a LogTag simply press and hold the START MARK button on the LogTag until both the OK
and Alert lights alternately flash on and off.
You can also have the LogTag record an "inspection" mark at any time while it is
recording, simply by pressing and holding the START MARK button on the LogTag until
both the OK and Alert lights flash on and off at the same time. You may have the LogTag
record as many inspection marks as you want while it is recording, however only one
inspection mark can be recorded per reading. In other words, if your LogTag is configured
to take readings at 15 minute intervals, inspection marks can be recorded at intervals of
15 minutes or more. If the LogTag has finished recording then pressing the START MARK
button will have no effect until after the LogTag has been prepared for next use.
The red light on the LogTag, also called the Alert light, will regularly flash to indicate that
a preset alert condition has been met and/or exceeded.
While the LogTag is recording after being started, the green light on the LogTag, also
called the OK light, will regularly flash every 4 seconds to indicate that it is still recording.
Once the LogTag has finished recording the green light will regularly flash every 8
seconds. However, if a preset alert condition has been met and/or exceeded then only the
Alert light will flash, even if the LogTag has finished recording.