Filter
Top Products
100 LogTag Analyzer
Toolbar commands
Each picture on the toolbar represents a unique command. The pictures that are included
on the toolbar represent the following commands:
This will bring up the LogTag Wizard, which will take you through the steps to retrieve
readings from connected LogTag(s) and prepare them for their next use.
This will display the file open window to allow you to locate and open LogTag files that
contain previously retrieved LogTag readings.
Save a copy of the LogTag data to a file on your disk drive.
Open the window that will allow you to print a copy of the LogTag data to a printer.
Displays file properties about the currently selected open file.
Displays information about any digital signatures included in the currently selected
open file, which is also allows where new digital signatures can be added to the file
and where you can print a copy of the digital signatures.
Creates a new blank email for sending a copy of the currently selected open file as an
attachment to a recipient of your choice.
Places a copy of the currently displayed information to the Windows clipboard so that
you can paste it into another Windows software package.
Zooms out one level of the actively displayed chart. If you are displaying a chart and
this function is not available, then all data that is available to be displayed is currently
been displayed and therefore there is no more additional information that can be
displayed by zooming out.
This zooms the chart to show information between the oldest reading recorded and
the first inspection mark that exists amongst the data. If this function is not available
then there is no inspection marks in the data currently been displayed. The next two
commands will not be available until this command is activated.
This zooms the chart to show the group of data that was recorded between the
previous inspection mark and the first inspection mark currently been displayed. This
function is disabled when either the oldest reading is already been displayed or the
chart has not been zoomed into showing groups of readings between inspection
marks.
This zooms the chart to show the group of data that was recorded between the next
inspection mark and the last inspection mark currently been displayed. This function is
disabled when either the newest reading is already been displayed or the chart has not
been zoomed into showing groups of readings between inspection marks.
Switches into Multi Chart mode, which displays all currently open charts together in
one window. Any additional charts that are opened will be added to the Multi Chart
window.
Switches into Single Chart mode. Each chart that is currently open will be displayed in
its own window.
This will open a window allowing you to customize the software. This command is
further explained in the chapter "
Customizing the software
".