Filter
Top Products
111
C HAPTER 10
Appendix
In This Chapter
Troubleshooting.....................................................111
Resolving USB Driver Problems ...............................113
Sensor Responsiveness...........................................136
Troubleshooting
Problem Solution
My LogTag appears to be “dead”. No
lights are flashing.
This could represent either of two conditions:
1 The LogTag is ready to start, but has not
been started yet.
2 The LogTag is simply in a state where the
configuration has the LED flashing turned
off. This is an option that may be selected
when a LogTag has been shipped to the
user for the first time (to preserve battery
life) or it may be that the last configuration
setting selected no LED display.
3 The LogTag is in "Hibernation" mode. Refer
to "
Prolonging battery life
" for further
information.
4 The battery is dead and the LogTag is
expired.
How to test:
1 Try pressing the START MARK button on the
LogTag.
2 Start the LogTag Analyzer software and
place the LogTag into the Interface Cradle.
Download the LogTag. If the LogTag can be
identified by the software, then the battery
is good, and the LogTag is OK.