PERIODIC MAINTENANCE 2-41
Maintenance Procedure
•
Set the dimmer switch to high beam position.
•
The low beam [A] and high beam [B] headlights should
go on.
•
The high beam indicator light (LED) [C] should go on.
If the high beam headlight and/or high beam indicator light
(LED) does not go on, inspect or replace the following
item.
Headlight High Beam Bulb (see Headlight Bulb Replace-
ment in the Electrical System chapter)
Dimmer Switch (see Switch Inspection in the Electrical
System chapter)
•
Turn off the engine stop switch.
•
The low beam and high beam headlights should stay go-
ing on.
If the headlights and high beam indicator light (LED) does
go off, inspect or replace the following item.
Headlight Relay in Relay Box (see Relay Circuit Inspec-
tion in the Electrical System chapter)
•
Turn off the ignition switch.
•
The headlights and high beam indicator light (LED) should
go off.
Headlight Aiming Inspection
•
Inspect the headlight beam for aiming.
If the headlight beam points to one side rather than
straight ahead, adjust the horizontal beam.
Headlight Beam Horizontal Adjustment
•
Turn the horizontal adjuster [A] in both headlights in or out
until the beam points straight ahead.
If the headlight beam points too low or high, adjust the
vertical beam.
Headlight Beam Vertical Adjustment
•
Turn the vertical adjuster [B] in both headlights in or out
to adjust the headlight vertically.
