16-96 ELECTRICAL SYSTEM
Immobilizer System (Equipped M odels)
Immobilizer System Parts Replacement
Immobilizer Antenna
•
Remove the left middle fairing (see Middle Faring Re-
moval in the Frame chapter).
•
Disconnect the lead connectors [A].
•
Remove:
Steering Stem Head (see Stem, Stem Bearing Removal
in the Steering chapter)
Handlebar (see Handlebar Removal in the Steering
chapter)
•
Using a small chisel or punch, turn out the Torx bolts [A].
•
Remove the clamp [B].
•
Cut the band [A].
•
Remove the screw [B].
•
Remove the antenna [C] with the cover [D].
○
Pull the lower parts [E] of the cover outside to clear the
projection [F] of the ignition switch.
•
Install the clamp.
•
Tighten a new Torx bolt [A] until the bolt head [B] is broken
[C].
•
Run the leads correctly (see Cable, Wire, and Hose Rout-
ing section in the Appendix chapter).
Immobilizer Amplifier Replacement
•
Remove the left middle fairing (see Middle Fairing Re-
moval in the Frame chapter).
•
Disconnect the connector [A].
•
Remove the amplifier [B] from the bracket [C].
