A SERVICE OF

logo

13-12 SUSPENSION
Front Fork
Install the clamps [A] as shown.
NOTE
Set the clamps so that the cutout [B] of the upper side
does not touch the tongue shape of stopper, pull up the
outer tube [C] to hold it by the clamps, and then tighten
the two bolts [D]. The outer tube is used as a guide.
Special Tools - Fork Spring Compressor: 57001-1587
Clamp: 57001-1626
Insert the holder bar [A] into the axle hole of the front fork
[B].
Insert the compression shaft [A] and install the nut.
Insert the lower end of the compression shaft [A] into the
hole [B] of the holder bar.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com