Support User Manuals

Invacare 1073955 Mobility Aid User Manual

Open as PDF

of 84

SECTION 9—REAR WHEELS

Part No. 1073955 63 Orbit

™

Replacing Handrims

Non-Projection Handrims

NOTE:Forthisprocedure,refertoFIGURE 9.3.

NOTE:Thefollowingprocedureswillworkforanytypeofprojectionhandrim.

Removing Non-Projection Handrims

1. Remove rearwheelfromthewheelchair.RefertoRemoving/InstallingRearWheelson

page 61.

2. Remove thebuttonscrewsthatsecurethehandrimtotherearwheelandremove

handrim.

Installing Non-Projection Handrims

NOTE:Forthisprocedure,referto

1. Installthenewhandrimontorearwheel.

2. Securehandrimtorearwheelwithbuttonscrews.

ƽ WARNING

Make sure detent pin and locking pins of the quick-release axles are fully released

before operating the wheelchair.

3. Reinstallrearwheelontothewheelchair.RefertoRemoving/InstallingRearWheels

onpage 61.

4. Ifthelockingpinsofthequick‐releaseaxlesarenotprotrudingpasttheinsideofthe

axlebushingorthereistoomuchmovementoftherearwheelassemblyinabackand

forthposition,refertoAdjustingtheQuick‐ReleaseAxleonpage 62.

5. Repeatprocedureforoppositerearwheel,ifnecessary.

FIGURE 9.3 Replacing Handrims - Non-Projection Handrims

Projection Handrims

NOTE:Forthisprocedure,refertoFIGURE 9.4onpage64.

NOTE:Thefollowingprocedureswillworkforanytypeofprojectionhandrim.

Handrim

Composite Rear

Wheels

Button

Screw

previous next