Filter
Top Products
SECTION 9—REAR WHEELS
Orbit
™
62 Part No. 1073955
FIGURE 9.1 Removing/Installing Rear Wheels
Adjusting the Quick-Release Axle
NOTE:Forthisprocedure,refertoFIGURE 9.2.
1. Remove rearwheelandquick‐releaseaxlefromthewheelchair.Referto
Removing/InstallingRearWheelsonpage 61.
2. Depressdetentpin(tip)inthequick‐releaseaxleandslideaxlethroughthewheelhub.
3. Releasedetentpinensuringthatthelockingpinsarefullyreleased.
4. Increaseordecreaseendplaybyadjustingthelocknutontheendofthequick‐release
axle.
ƽ WARNING
Make sure the detent pin and locking
pins of the quick-release axle are fully
released before operating the
wheelchair.
Keep locking pins clean.
5. Reinstallrearwheelontowheelchair.
RefertoRemoving/InstallingRear
Wheelsonpage 61.
FIGURE 9.2 Adjusting the Quick-Release
Axle
Axle Mounting
Plate
DETAIL “A” -
QUICK-RELEASE
AXLE
Quick-Release Axle
Axle
Bushing
Rear Wheel
Head
End
DETAIL “B” -
PERMANENT
AXLE
Axle Mounting Plate
Mounting Screw
Locknut
Axle Bushing
Locking
Pins
Axle
Mounting
Plate
Quick-Release Axle
Locknut
Detent
Pin
Wheel Hub