Support User Manuals

Invacare 1073955 Mobility Aid User Manual

Open as PDF

of 84

SECTION 5—FRONT RIGGINGS

Orbit

™

38 Part No. 1073955

FIGURE 5.12 Replacing Sector Block

Installing/Removing/Adjusting the Telescoping Front

Frame Tubes

NOTE:Forthisprocedure,refertoFIGURE 5.13onpage39.

Installing/Removing Telescoping Front Frame Tubes

1. Ifnecessary,removethebilateralcontractureplatformfromthewheelchair.Referto

BilateralContracturePlatformProceduresonpage 35.

2. Insertonetelescopingtubeintoseatrail.

3. Adjusttooneofthreedepthpositions.

4. Securewithmountingscrewandlocknut.

5. RepeatSTEPS2‐3foroppositeseatrail.

6. Toremove,performthefollowing:

A. Removethemountingscrewandlocknutthatsecuresthetelescopingtubetothe

seatrail.

B. Removethetelescoping

tubefromtheseatrail.

Adjusting Telescoping Front Frame Tubes

1. Remove themountingscrewandlocknutthatsecuresthetelescopingtubetotheseat

rail.

2. Adjusttelescopingtubetodesireddepth.

3. Reinsertmountingscrewandsecurewithlocknut.

4. Repeatforoppositetelescopingfrontframetube.

Mounting

Screw

Washer

Locking Pin

Sector

Block

Wheelchair Frame

previous next