Support User Manuals

Invacare 1073955 Mobility Aid User Manual

Open as PDF

of 84

SECTION 6—ARMS

Orbit

™

48 Part No. 1073955

ƽ WARNING

DO NOT over tighten the locknut that secures the locking lever to the bottom

bracket. Over tightening this locknut will prevent the locking lever from operating

properly, possibly causing injury.

7. Installthephillipsboltandtightensecurelywiththelocknut.

8. InstalltheT‐armontothewheelchair.RefertoInstalling/RemovingtheT‐armson

page 42.

FIGURE 6.8 Replacing the T-Arm Locking Lever

Using/Installing/Adjusting Cantilever Arms

NOTE:Forthisprocedure,refertoFIGURE 6.9onpage49.

NOTE:Cantileverarmsareavailableonnon‐reclinermodelsonly.

Using Catilever Arms

1. Pulltheactuatorofthelockingmechanismtowardsthefrontofthewheelchair.

2. Whileholdingtheactuatorofthelockingmechanism,pulluponthecantileverarm.

NOTE:Ifnecessary,thelockingmechanisminthecantileverarmcanberepositionedsothe

cantileverarmwillopendowninsteadofup.RefertoReplacing/RepositioningtheLocking

MechanismintheCantileverArmonpage 50.

3. Tolockthecantileverarm,pushdownuntilthereisanaudibleclick.

4. Pulluponthecantileverarmtomakesureitislockedinplace.

Bottom

Bracket

Phillips Bolt

Locking

Lever

Spring

Extended Ends

Locknut

Notch

previous next