Filter
Top Products
52 Micro Motion
®
Series 3000 MVD Transmitters
Operation Mode – NOC
5.3.2 Pausing and resuming Continuous mode measurement
Use the Pause / Resume option shown in Figure 5-3 to pause and resume Continuous mode
measurement. While measurement is paused, no data is collected, displayed, or stored, and average,
minimum, maximum, total, or inventory values are not updated.
You can pause and resume measurement as often as you wish.
Table 5-7 Production data accessible via View Production Measurement screen – Continuous mode
Process variable
Values
Actual Avg Min
Min
time/
date Max
Max
time/
date Total
Reset
time/
date Inventory
Net oil YYYYYYYYY
Water cut YYYYYY Y
Gross flow YYYYYYYYY
Net water YYYYYYYYY
Drive gain Y Y Y Y Y
Density YYYYYY Y
Temperature YYYYYY Y
Back flow Y YYYYY
Mass flow YYYYYYYYY
TMR drive gainYYYYYY
Gas volume YYYYYYYYY
Uncorrected flow
Uncorrected oilYYYYYYYYY
Uncorrected waterYYYYYYYYY
Uncorrected water
cut
YYYYYY Y
Uncorrected grossYYYYYYYYY
Table 5-8 TMR data – Continuous mode
Process variable Definition
Mass flow rate Current mass flow rate from the gas meter
2-phase mass total Total mass of liquid and gas in the gas stream during all TMR intervals
TMR mass total Calculated mass of gas in the gas stream during all TMR intervals
Mass carry-over Total mass of liquid in the gas stream during all TMR intervals (2-phase mass total minus TMR
mass total)
Oil volume carry-over Volume of oil in gas stream during all TMR intervals
Water volume carry-over Volume of water in gas stream during all TMR intervals
Transient mist time Hours and minutes that TMR has been active