Filter
Top Products
Net Oil Computer Supplement 17
NOC Overview NOC ConfigurationUsing the DisplayBefore You Begin
Chapter 3
Using the Display and Menu System
3.1 About this chapter
This chapter explains how to use the Series 3000 display and menu system. Using the display, you can
move through the menus, configure the application, monitor and control the application, and perform
maintenance and diagnostic tasks:
All NOC operations are accessed from the Well Performance Measurement screen.
All configuration, maintenance, and other functions are accessed via the Management menu.
3.2 Startup and Well Performance Measurement screen
When the Series 3000 device is powered on, it automatically tests its display. During display testing,
the screen darkens for approximately five seconds. After the display test is completed:
1. The Micro Motion logo is displayed for two to three seconds.
2. An application list is displayed for two to three seconds.
3. The device enters operation mode and the Well Performance Measurement screen is displayed,
as shown in Figure 3-1. There are two versions of this screen, depending on whether the NOC
application is in Continuous mode or Well Test mode. All NOC operations are accessed from
this screen.
4. If there are any active alarms, the alarm category will be displayed in the alarm bar. To view,
acknowledge, or respond to the alarms, see Chapter 6.
Figure 3-1 Well Performance Measurement screen
Well Performance Meas
View Production Meas
Quick View
Pause / Resume
Reset
Save
SEL HELP EXIT
Well Performance Meas
Start Well Test
View Well Tests
Recalculate Well Test
SEL HELP EXIT
Continuous mode Well Test mode