Filter
Top Products
Net Oil Computer Supplement 23
NOC Overview NOC ConfigurationUsing the DisplayBefore You Begin
Chapter 4
Configuring the NOC Application
4.1 About this chapter
This chapter explains how to configure the NOC application and perform density determination
procedures.
The following topics are discussed:
• Basic configuration procedure – see Section 4.3
• Setting up a water cut monitor – see Section 4.4
• Setting up pressure compensation – see Section 4.5
• Setting up Transient Bubble Remediation – see Section 4.6
• Setting up gas measurement – see Section 4.7
• Setting up Transient Mist Remediation – see Section 4.8
• Performing density determination procedures – see Section 4.9
- Density determination for water – see Section 4.9.1
- Density determination for oil – see Section 4.9.2
Failure to perform configuration tasks in the proper sequence could result in an incomplete
configuration. See Section 1.3 for the recommended configuration sequence.
4.2 Well Performance Measurement menu
Use the Well Performance Measurement menu, shown in Figure 4-1, to access and configure NOC
parameters. The Well Performance Measurement menu is accessed through the Configuration option
of the Management menu. To access the Management menu, see Chapter 3.
Do not change configuration during data collection. Changes made to the NOC configuration will affect
NOC measurement. Changes made to other configuration parameters may affect NOC measurement.
To ensure accurate NOC data, follow the instructions in Section 5.2.4 (Well Test mode) or Section 5.3.4
(Continuous mode) to change configuration.