Filter
Top Products
28 Micro Motion
®
Series 3000 MVD Transmitters
Configuring the NOC Application
10. If desired, configure the process monitor to display NOC process variables. Instructions for
configuring the process monitor are in the manual entitled Series 3000 MVD Transmitters and
Controllers: Configuration and Use Manual. The following NOC process variables can be
assigned to the process monitor:
•External Water Cut
• Uncorrected Water Cut
•Net Water Cut
• Uncorrected Oil Volume Rate
• Uncorrected Oil Total
• Uncorrected Oil Inventory
• Uncorrected Water Volume Rate
• Uncorrected Water Total
• Uncorrected Water Inventory
• Back Flow Rate
• Back Flow Total
• Back Flow Inventory
• Net Oil Flow Rate
• Net Oil Total
• Net Oil Inventory
•Net Water Flow Rate
•Net Water Total
•Net Water Inventory
• Gross Volume Rate
• Gross Volume Total
• Gross Volume Inventory
• Gas Volume Flow Rate
•Gas Volume Total
•Gas Volume Inventory
Note: The process monitor may also be used to display other variables such as external pressure,
external temperature, etc. This may be useful to verify setup and configuration.