Filter
Top Products
Net Oil Computer Supplement 1
NOC Overview NOC ConfigurationUsing the DisplayBefore You Begin
Chapter 1
Before You Begin
1.1 About this manual
This manual explains how to configure and use the Net Oil Computer application on the
Micro Motion
®
Series 3000 MVD platform (a Model 3500 or Model 3700 MVD transmitter).
This manual does not provide information on basic installation, configuration, and use of the
Model 3500 or Model 3700 transmitter. For basic platform information and instructions, see the
manual entitled Micro Motion
®
Series 3000 MVD Transmitters and Controllers: Configuration and
Use Manual.
1.2 Communication tools
You can communicate with a Series 3000 device using any of the following communication tools:
• The local display
• ProLink II v2.5 and higher (ProLink II v2.7 recommended)
• 375 Field Communicator with the appropriate DD:
Micro Motion 3000 Mass flo v7 DD v2
To configure or use the NOC application, you must use either the local display or ProLink II v2.7.
This manual focuses on the use of the local display. Detailed menu flowcharts for the local display are
provided throughout this manual and in Appendix A.
For general information on installing ProLink II and connecting to the Series 3000 platform, see the
manual entitled Micro Motion
®
Series 3000 MVD Transmitters and Controllers: Configuration and
Use Manual.
1.3 Manuals and manual use
Table 1-1 lists the basic steps required to install, set up, configure, and use the Series 3000 device with
the NOC application. Table 1-1 also identifies the manual in which the associated information is
provided. Note that for some tasks you will need to use both manuals.