Filter
Top Products
36 Micro Motion
®
Series 3000 MVD Transmitters
Configuring the NOC Application
9. The NOC application converts the observed water density to water density at reference
temperature, and displays a screen similar to Figure 4-8. This screen also displays the stored
value for water density at reference temperature, and the date and time at which this value was
stored.
• To replace the stored value with the new value, press
SAVE.
• To discard the data from this procedure, press
EXIT. You will be returned to the Procedure
Selection screen. From this point you can repeat the density determination procedure or
press
EXIT to move up the menu and return to other functions.
Figure 4-8 Density determination for water – Manual procedure results
4.9.2 Performing a density determination for oil
To perform a density determination for oil:
1. Ensure that the correct fluid (oil) is flowing through the sensor. You may need to drain water
from the separator.
2. From the Calibration menu, select
Density Determination and work through the screens until
the Procedure Selection screen (see Figure 4-3) is displayed. In Well Test mode, you will be
required to select the well for which the procedure will be performed.
3. From the Procedure Selection screen, select
Oil Density. The screen shown in Figure 4-9 is
displayed.
Manually Enter
Water Density @ Ref
x.xxxx g/cm3
Water Density at
dd-mm-yy hh:mm
Current Dens @ Ref
x.xxxxx g/cm3
Current Dens Saved
dd-mm-yy hh:mm
SAVE HELP EXIT