Filter
Top Products
Figure 12. Removing and Installing the System Feet
1. base of the tower 2. system feet (4)
3. screws (4)
Installing The System Feet
1. Lay the system on its side on a flat, stable surface.
2. Secure the system feet to the base of the tower using the screws.
3. Place the system upright on a flat, stable surface and turn the system feet outward.
Wheel Assembly (Optional)—Tower Mode
The wheel assembly provides mobility to the system in the tower mode.
The wheel assembly consists of the following:
• Wheel assembly units (front and back)
• Two screws for the wheel assembly units
• Support unit with two screws
Removing The Wheel Assembly
1. Lay the system on a sturdy, stable surface with the wheel assembly extending off the edge of the surface.
2. Remove the two screws securing the support unit to the base of the chassis and pull out the support unit.
3. Remove the screw securing the front wheel assembly unit to the base of the chassis.
42