Remote Maintenance by telnet
99
9
Note
❒ When changing the interface to
IEEE 802.11b, see p.90 “TCP/IP
address”.
❒ When configuring the IEEE
802.11b TCP/IP, see p.90 “TCP/IP
address”.
Job Spool
Use the "spoolsw" command to con-
figure Job Spool settings.
Limitation
❒ You can only specify LPR, IPP, and
SMB protocol.
Note
❒ This information cannot reload au-
tomatically when you confirm Job
Spool settings with the Web
browser. Click [Reload] or [Refresh]
on the Web browser when you
want to reload this information.
❖
❖❖
❖ Reference
The Job Spool setting appears.
msh> spoolsw
❖
❖❖
❖ Job Spool setting
msh> spoolsw spool {on | off}
Note
❒ Select [on] to enable Job Spool or
[off] to disable it.
❖
❖❖
❖ Protocol configuration
To change protocol settings, use
the following command. You can
specify the setting for "lpr", "ipp"
or "smb".
• lpr
msh> spoolsw lpr {on | off}
• ipp
msh> spoolsw ipp {on | off}
• smb
msh> spoolsw smb {on | off}
Changing the host name
Use the "hostname" command to
change the printer name.
msh> hostname interface_name
printer_name
*1
If you did not enter the interface
name, it will be automatically set to
the Ethernet interface.
*2
Available when the optional 802.11b
interface kit is installed.
*3
Available when the optional 1394 in-
terface board is installed.
Note
❒ Enter the printer name using up to
15 characters.
❒ You cannot use a printer name
starting with "RNP" or "rnp".
❒ The Ethernet interface and IEEE
802.11b interface will have the
same printer name.
WINS
Use the "wins" command to configure
WINS server settings.
❖
❖❖
❖ Viewing setting
The following command displays
the WINS server IP address:
msh> wins
Example output:
Interface name
Interface to be configured
ether Ethernet interface
*1
wlan
*2
IEEE 802.11b interface
ip1394
*3
IEEE 1394 interface
