A SERVICE OF

logo

Open as PDF
next previous
Appendix
98
9
ssid ID value You can set SSID in
infrastructure
mode.
The characters that
can be used are
ASCII 0x20-0x7e
(32 bytes).
SSID value is set
automatically to
the nearest access
point if the setting
has not been made.
If the setting has
not been made for
ad hoc mode, the
same value as for
infrastructure
mode or an “AS-
SID” value is auto-
matically set.
channel frequency
channel no.
You can set the
channel.
You can specify
from the following
channels:
• Metric Version
: 1-13
• Inch Version :
1-11
Set the same chan-
nel for all the ma-
chines you are
using.
enc [on|off] You can enable or
disable the WEP
function. To enable
the WEP function,
select [on]; to disa-
ble it, select [off].
To start the WEP
function, enter the
correct WEP key.
Parameter Value to be
configured
key [key value] 64-bit or 128-bit
can be set.
Only 10 hexadeci-
mal characters can
be set when using
64-bit; or 26 hexa-
decimal characters
when using 128-bit.
Also, set 0x as the
prefix.
To use this func-
tion, set the same
WEP key for all
ports that transmit
to each other.
auth
[open|shared]
You can set the au-
thorized mode
when using WEP.
The specified val-
ue and the author-
ized mode are as
follows:
open: Open system
authorized (de-
fault)
shared: Shared key
authorized
rate [au-
to|11m|5.5m|2m
|1m]
You can set the
IEEE 802.11b trans-
mission speed.
The transmission
speed you specify
here is the speed at
which data is sent.
You can receive
data at any speed.
auto: automatical-
ly set (default)
11m: 11 Mbps fixed
5.5m: 5.5 Mbps fixed
2m: 2 Mbps fixed
1m: 1 Mbps fixed
Parameter Value to be
configured