Philips MP20/30 Medical Alarms User Manual


 
18 Monitoring EEG Changing EEG Settings
212
Changing CSA Settings
When CSAs are shown embedded on the Main Screen, select the CSA to show the pop-up keys. When
the CSA is shown in a window over the current screen, the pop-up keys are always displayed.
Changing EEG Settings
Be aware that any changes made to EEG settings apply to both EEG channels.
Switching EEG Numerics On and Off
Each EEG numeric can be individually switched on or off in the Setup EEG menu.
1 In the Setup EEG menu, select the numeric label.
2 Select On/Off to toggle between the settings.
Changing the Scale of the EEG Waves for Display
This only changes the visual appearance of the wave. It does not affect the signal analyzed by the
monitor or printed in reports or recordings.
1 In the Setup EEG menu, select Wave Scale to call up a list of wave scales.
2 Select the required scale from this list.
Scaling information is displayed with each EEG wave.
•If
Show Gridlines is set to On in Configuration Mode, gridlines and the current wave scale
values are shown with the EEG wave.
•If
Show Gridlines is set to Off in Configuration Mode, the current wave scale is indicated by a
size bar beside the EEG wave.
Setup CSA This menu entry lets you
Buffer choose one of the three pre-configured buffers. A buffer defines the interval
between the spectral lines displayed in the CSA.
On/Off SEF/MDF/PPF switch the trendline of the specific numeric on or off