Philips MP20/30 Medical Alarms User Manual


 
Care Groups 5 Managing Patients
89
Automatic alarm notification can be switched off permanently in the monitor’s Configuration Mode
or at the Information Center. To temporarily disable and re-enable automatic alarm notification at the
bedside monitor, for example if you want to carry out a procedure, in Monitoring Mode:
1 Select the network symbol on the monitor screen to call up the Network menu.
2 Select Auto Window to toggle between the settings Enabled and Disabled.
This setting resets to the default at discharge and when the monitor is switched on. Always re-enable
the Auto Window as soon as possible.
Telemetry Data Overview
You can assign a monitor and a telemetry device to the same patient. This is called “pairing” and is
done at the Information Center. In paired mode, the telemetry data can be displayed as a permanent
overview session on the monitor. To do this, one of the available Screens must have the Telemetry
Data Overview screen element embedded. If configured, this Screen will automatically display when
the monitor is paired with a telemetry device at the Information Center. Be aware that the data from a
paired telemetry device is stored at the Information Center and not in the monitor.
Unpairing a Telemetry Device
To disconnect the patient from the telemetry device and reconnect them to the monitor
(for example, to see realtime waves),
select the Unpair Equipment SmartKey to have the Information Center receive
the ECG data from the monitor again. In this case data from the telemetry device will
no longer be monitored at the Information Center. (Behavior depends on the revision of your
Information Center.)
or
use the Unpair function at the Information Center. In this case you can decide whether the
Information Center will continue to monitor data from the telemetry device.