Filter
Top Products
27
6. Assembly
6.10 Inserting the batteries (DM1000 LED only)*
The microscope can be powered by batteries if
you prefer. The batteries are automatically
charged when the microscope is connected to
the mains supply.
The microscope can be used for about 6-8 hours
in battery-operated mode.
• The battery compartment is accessed from
underneath the stand (23a.1); remove the lid
of the compartment
• Insert the batteries (order no. p. 56) as shown
on the bottom of the compartment (fig. 23b)
and close the lid
6.11 Connection to the Power Supply
• After completing the assembly work, connect
the stand to the power supply using the power
cable supplied (fig. 23c)
• When using the lamp housing or the
external power supply unit, connect them to
the power supply, too
Fig. 23c Back of the stand (DM1000)/Type label
1 Power supply connection
Fig. 23b Bottom of stand (DM1000 LED)
1 Battery compartment open
Fig. 23a Bottom of stand (DM1000 LED)
1 Lid of the battery compartment
Fig. 23d Back of the stand (DM1000 LED)/Type label
1 External power supply connection
1
1
1
1