Filter
Top Products
33
A
R
M
S
PROCEDURE 4
ARMS
INSTALLING RIGID CLOTHING
GUARDS (FIGURE 12)
1. Position the threaded and unthreaded half clamps
on inside and outside of the wheelchair frame.
NOTE: Make sure the threaded half clamp is on the
outside of the wheelchair frame.
2. Loosely install the washer and socket screw into
the unthreaded and threaded half clamps.
3. Determine the desired rigid clothing guard posi-
tion and securely tighten the two (2) half clamps
together with the socket screw.
4. Insert the rigid clothing guard into the slot on the
threaded half clamp as shown in FIGURE 12.
5. Repeat STEPS 1-4 for the opposite rigid side
guard.
FIGURE 12 - INSTALLING RIGID CLOTHING
GUARDS
Threaded Half Clamp
Washer
Wheelchair
Frame
Unthreaded
Half Clamp
Socket Screw
Slot
Rigid
Clothing
Guard