Filter
Top Products
14
FIGURE 2 - ADJUSTING FOOTREST HEIGHT
Hex Screw
Coved Washer
Footrest
FOOTRESTPROCEDURE 1
F
O
O
T
R
E
S
T
FIGURE 1 - INSTALLING/REMOVING
FOOTREST(S)
Mounting Tube
Footrest Mounting Pin
Footrest Release Lever
NOTE: The following procedures are for Pro-SA Model
Wheelchairs only, except where specified.
INSTALLING/REMOVING
FOOTREST(S) (FIGURE 1)
NOTE: Remove the footrests from the wheelchair by re-
versing this procedure.
1. Turn the footrest to the side (open footplate is perpen-
dicular to wheelchair).
2. Insert footrest mounting pin into mounting tube.
3. Push the footrest towards the inside of the wheel-
chair until it locks into place.
NOTE: The footplate will be on the inside of the wheelchair
when locked in place.
4. Repeat this procedure for other footrest assembly.
5. To release the footrest, push the footrest release le-
ver inward, rotate footrest outward.
ADJUSTING FOOTREST HEIGHT
(FIGURE 2)
NOTE: Release the footrest locking mechanism and lift
the footrest mounting pins out of its mounting tube. Lay
the assembly on a flat surface to simplify this procedure.
NOTE: Make sure to note the position of the washers
before disassembly.
1. Remove impact guards and/or calf strap, if neces-
sary.
2. Remove the hex screw and coved washer and posi-
tion the footrest assembly to a determined height.
3. Lineup the mounting hole in the footrest frame, rein-
sert the hex screw and coved washer; hand-tighten.
4. Securely tighten the hex screw and coved washer.
5. Repeat this procedure for the other footrest, if neces-
sary.
6. Replace impact guards and/or calf strap, if neces-
sary.
INSTALLING ADJUSTABLE ANGLE
FLIP-UP FOOTPLATE HINGE
(FIGURE 3)
NOTE: This procedure is for individual adjustable angle
footrests only.
1. Position the adjustable angle flip-up footplate
(footplate) hinge on the footrest support tube at the
desired height.
2. Position the hardware on the footrest support as
shown in FIGURE 3.
This Procedure includes the following:
Installing/Removing Footrest(s)
Adjusting Footrest Height
Installing Adjustable Flip-Up Footplate Hinge
Installing/Adjusting Adjustable Angle Flip-Up
Footplates
Impact Guards/Calf Strap
Replacing Heel Loops
Installing/Removing Elevating Legrests
Raising/Lowering Elevating Legrests and/or
Adjusting Calfpads
Installing Basketball Roller
WARNING
After adjustments and BEFORE use, make
sure all attaching hardware is securely
tightened, otherwise injury or damage
may occur.