Filter
Top Products
20
FIGURE 4 - ADJUSTABLE TENSION BACK
UPHOLSTERY - INSTALLING/REPLACING
ADJUSTABLE TENSION BACK UPHOLSTERY
Back Upholstery Cover
Fastening Strap
Fastening Strap
Frame
Anchor Loops
Adjuster
Straps
Mounting Screws
Back Upholstery
Fastening
Flap
Fastening
Flap
Back
Canes
FIGURE 3 - BACK UPHOLSTERY -
REMOVING/INSTALLINGADJUSTING
OPTIONAL BACK UPHOLSTERY - BACK
CANES WITHOUT PUSH HANDLES
NOTE: The back canes must be mounted in the same
height adjustment hole.
5. Securely tighten the new/existing back upholstery to
the back canes with the two (2) phillips screws and
washers.
6. Secure the bottom of the new/existing back uphol-
stery to the wheelchair frame with tie-wraps.
Removing/Installing Optional Back
Upholstery - Back Canes Without Push
Handles (FIGURE 3)
REMOVING.
1. Unlatch the two (2) fastening flaps that secure the
bottom of the existing back upholstery to the back
canes.
2. Lift up on the top of the existing back upholstery to
unlatch.
3. Lift up on the existing back upholstery and remove
from the wheelchair.
4. Install the new/existing back upholstery onto the wheel-
chair. Refer to the following procedure.
INSTALLING.
1. Position the new/existing back upholstery over the two
(2) back canes.
2. Securely latch the fastening flaps on the bottom of the
new back upholstery to the back canes.
3. Adjust the NEW back upholstery to the desired height.
Refer to the following procedure.
ADJUSTING.
1. Unfold the top of the back upholstery.
2. Adjust the back upholstery to the desired height.
3. Resecure the top of the back upholstery.
Adjustable Tension Back Upholstery
INSTALLING ADJUSTABLE TENSION BACK
UPHOLSTERY (FIGURE 4).
1. Remove the existing back upholstery from the
wheelchair. Refer to REMOVING/INSTALLING
OPTIONAL BACK UPHOLSTERY - BACK
CANES WITH PUSH HANDLES, REMOVING/
INSTALLING OPTIONAL BACK UPHOLSTERY
- BACK CANES WITHOUT PUSH HANDLES or
REPLACING ADJUSTABLE TENSION BACK
UPHOLSTERY in this procedure of the manual.
2. Slide each section (anchor loop/adjuster strap) of
the adjustable tension back upholstery onto the two
(2) back canes with the grommet hole facing the
rear of the wheelchair.
3. Secure the adjustable tension back upholstery to
the back canes with the mounting screws and
washers.
NOTE: Clean the upholstery with warm water and mild
detergent to remove superficial soil.
UPHOLSTERYPROCEDURE 2
U
P
H
O
L
S
T
E
R
Y
Adjustable Tension
Back Upholstery
Washers
Grommet Hole