Filter
Top Products
19
U
P
H
O
L
S
T
E
R
Y
PROCEDURE 2UPHOLSTERY
BACK UPHOLSTERY
Removing/Installing Optional Back
Upholstery - Back Canes with Push Handles
(FIGURE 2)
REMOVING.
1. Cut the tie-wraps that secure the bottom of the exist-
ing back upholstery to the wheelchair frame.
2. Remove the two (2) phillips screws and washers that
secure the existing back upholstery to the back canes.
3. Remove the allen screw and locknut that secure one
(1) back cane to the wheelchair frame.
NOTE: It is necessary to remove only one (1) back cane
to replace the back upholstery.
4. Pull the loose back cane out of the existing back up-
holstery.
5. Pull the existing back upholstery up and over the
mounted back cane.
6. Install the new upholstery onto the wheelchair.
Refer to the following procedure.
INSTALLING.
1. Position the new back upholstery over the mounted
back cane.
2. Slide the new back upholstery over the mounted
back cane.
3. Slide the loose back cane through the new back up-
holstery.
4. Using the mounted back cane as a guide, reinstall the
loose back cane to the wheelchair frame with the ex-
isting allen screw and locknut.
This Procedure includes the following:
Replacing Seat Upholstery
Back Upholstery
Installing Fabric Clothing Guards
WARNING
After adjustments and BEFORE use, make
sure all attaching hardware is securely
tightened, otherwise injury or damage
may occur.
REPLACING SEAT UPHOLSTERY
(FIGURE 1)
1. Remove the seat cushion, if necessary, from the
wheelchair.
2. Remove the twelve (12) phillips screws that se-
cure the existing seat upholstery to the seat frame.
3. Remove the existing seat upholstery.
4. Install the new seat upholstery by reversing STEPS
1-3.
5. If necessary, reinstall the seat cushion onto the
wheelchair.
Seat
Upholstery
Phillips
Screws
Fastening Straps
FIGURE 1 - REPLACING SEAT UPHOLSTERY
Back Upholstery
Phillips
Screw
Washer
Washer
Tie Wrap
Mounting
Hole
Phillips Screw
FIGURE 2 - BACK UPHOLSTERY -
REMOVING/INSTALLING OPTIONAL BACK
UPHOLSTERY - BACK CANES WITH PUSH
HANDLES