Filter
Top Products
32
PROCEDURE 4 ARMS
A
R
M
S
INSTALLING FLIP BACK ARMS
(FIGURE 10)
NOTE: This option is not available for wheelchairs
equipped with amputee attachments or fixed backs.
1. Position the armrest bracket on the wheelchair
frame. Refer to FIGURE 10 for correct orienta-
tion.
2. Install the two (2) hex bolts and four (4) washers
through the armrest bracket and wheelchair frame
as shown in FIGURE 10.
3. Install locknuts onto the two (2) hex bolts and tighten
securely.
4. Install the armrest snap into the wheelchair frame.
5. Line up the mounting holes armrest snap and
wheelchair frame.
6. Install the hex bolt, washer and spacer as shown
in FIGURE 10.
7. Install a locknut onto the hex bolt and tighten se-
curely.
8. Install the flip back arm onto the mounting pin on
the armrest bracket.
NOTE: The armrest pad should be towards the out-
side of the wheelchair.
9. Rotate the arm upward and lock into the armrest
snap.
10. Repeat STEPS 1-9 for the opposite side of the
wheelchair.
ADJUSTING FLIP BACK ARMS
(FIGURE 11)
Length
1. Remove the rear phillips screw that secures the
armrest pad to the flip back arm tube.
2. Move the armrest pad to one (1) of four (4) posi-
tions.
3. Reinstall the phillips screw that secures the arm-
rest pad to the flip back arm tube and tighten se-
curely.
4. Repeat STEPS 1-3 for the opposite flip back arm,
if necessary.
Height
1. Remove the hex screw that secures the flip back
arm tube to the flip back arm tube plug.
2. Move the flip back arm tube to one (1) of six (6)
positions.
3. Reinstall the hex screw that secures the flip back
arm tube to the flip back arm tube plug and tighten
securely.
4. Repeat STEPS 1-3 for the opposite flip back arm,
if necessary.
FIGURE 10 - INSTALLING FLIP BACK ARMS FIGURE 11 - ADJUSTING FLIP BACK ARMS
Flip Back Arm
Locknuts
Washers
Armrest
Bracket
Wheelchair Frame
Hex Bolts
Washers
Locknut
Spacer
Armrest
Snap
Hex Bolt
Washer
Flip Back
Arm Tube
Rear
Phillips
Screws
Armrest
Pad
Flip Back Arm
Tube Plug
Hex
Screw
Mounting
Pin