Invacare Pro Series Mobility Aid User Manual


 
17
Calfpad
Bolt and Nut
Footrest
Assembly
Footplate
Legrest
Release
Handle
Mounting Pin
Mounting Tube
FIGURE 9 - INSTALLING ELEVATING
LEGRESTS
FOOTREST PROCEDURE 1
F
O
O
T
R
E
S
T
NOTE: Remove the footrests from the wheelchair by re-
versing this procedure.
RAISING/LOWERING ELEVATING
LEGRESTS AND/OR ADJUSTING
CALFPADS (FIGURE 10)
Raising/Lowering Elevating Legrests
1. Perform one (1) of the following:
RAISING - Pull back on the release lever until
the leg is at the desired height.
LOWERING - Support leg with one (1) hand and
push release lever downward with
other hand.
Adjusting Calfpads
1. To adjust the calfpad, turn pad towards the
outside of the wheelchair.
2. Slide the calfpad up or down until the desired
position is obtained.
3. To secure the calfpad, turn the calfpad towards
the inside of the wheelchair.
FIGURE 10 - RAISING/LOWERING
ELEVATING LEGRESTS AND/OR ADJUSTING
CALFPADS
6. Reverse preceding steps to reassemble.
NOTE: When securing the heel loop to the footrest as-
sembly, tighten the phillips screw and locknut until the
spacer is secure.
Adjustable Footplate
1. Remove the four (4) phillips screws and washers that
secure the existing heel loop to the footplate.
2. Position the mounting holes of the new heel loop with
the mounting holes in the adjustable footplate.
3. Secure the new heel loop to the footplate with the four
(4) phillips screws and washers.
INSTALLING/REMOVING
ELEVATING LEGRESTS
(FIGURE 9)
NOTE: Remove the legrests from the wheelchair by re-
versing this procedure.
1. Insert the pivot tube into the legrest support and se-
cure it with the bolt and nut.
2. Place legrest on the outside of the wheelchair and
insert the mounting pin into the mounting tube.
3. Rotate legrest toward the inside of the wheelchair until
it locks in place.
NOTE: The footplate will be on the inside of the wheelchair
when locked in place.
4. Repeat STEPS 1-3 for the opposite legrest.
5. After seated in wheelchair, adjust footrest to correct
height by loosening nut and sliding the pivot tube up or
down until desired height is obtained.
Calfpad
Release Lever
Secure Calfpad
Adjust Calfpad
Pivot
Tube