Filter
Top Products
29
PROCEDURE 4
ARMS
A
R
M
S
FIGURE 3 - INSTALLING/REMOVING
THE T-ARMS
Width (FIGURE 5)
1. Remove the two (2) phillips screws that secure
the arm pad to the arm tube.
2. Turn the arm pad around and reposition the arm
pad on the arm tube.
3. Re-secure the arm pad to the arm tube with the
two (2) phillips screws. Tighten securely.
4. Repeat for the opposite side, if necessary.
FIGURE 5 - ADJUSTING THE T-ARMS -
WIDTH
Phillips
Screw
Arm Tube
Phillips Screw
Arm Pad
Depth (FIGURE 6)
1. Remove the two (2) phillips screws that secure
the arm pad to the arm tube.
2. Remove the two (2) socket screws that secure
the arm tube to the T-arm post.
ADJUSTING THE T-ARMS
Height (FIGURE 4)
1. Unlock the T-arm by flipping the T-arm release le-
ver towards the inside of the wheelchair.
NOTE: If necessary, pull out on the T-arm release le-
ver and rotate 180
o
so it can be flipped towards the
outside of the wheelchair.
2. Slide the T-arm to one (1) of:
A. Low Height T-arms - Nine (9) positions.
B. High Height T-arms - Seven (7) positions.
NOTE: If the inside T-arm post does not slide up and
down in the outside T-arm post as desired, perform
one (1) of the following:
A. Tighten - Tightening the set screws on the
outside T-arm post will make it harder to
move the inside T-arm post up and down.
B. Loosen - Loosening the set screws on the
outside T-arm post will make it easier to move
the inside T-arm post up and down.
3. Lock the T-arm by flipping the T-arm release lever
towards the front of the wheelchair.
FIGURE 4 - ADJUSTING THE T-ARMS -
HEIGHT
Set
Screws
T-arm Release
Lever - Unlocked
Position
Inside T-arm
Post
Outside T-
arm Post
T-arm Release Lever -
Locked Position
T-arm
Socket
Slot
Locking Lever
(Towards the
front of the
wheelchair.)
T-arm
Wheelchair
Frame