Filter
Top Products
31
3. Perform one (1) of the following:
Small Side Guards - Move the bottom clamp up one
(1) of two (2) mounting posi-
tions in the side guard.
Large Side Guards - Move the bottom clamp up one
(1) of three (3) mounting posi-
tions in the side guard.
4. Re-secure the side guard to the bottom clamp with
the two bottom (2) socket screws.
5. Install the T-arm onto the wheelchair. Refer to IN-
STALLING/REMOVING THE T-ARMS in this pro-
cedure of the manual.
3. Remove the existing locking lever and spring from
the bottom bracket.
NOTE: Inspect the spring and replace if necessary.
4. Position the spring on the bottom bracket as shown
in FIGURE 9.
5. Position the new locking lever onto the spring and
the bottom bracket.
NOTE: Make sure the two (2) extended ends of the
spring are inside the notch in the locking lever.
6. Line up the mounting holes in the new locking le-
ver, spring and bottom bracket.
WARNING
DO NOT over tighten the locknut that
secures the locking lever to the bottom
bracket. Over tightening this locknut
will prevent the locking lever from op-
erating properly, possibly causing injury.
7. Install the phillips bolt and tighten securely with the
locknut.
8. Install the T-arm onto the wheelchair. Refer to IN-
STALLING/REMOVING THE T-ARMS in this pro-
cedure of the manual.
FIGURE 8 - ADJUSTING THE TRANSFER
ASSISTS AND/OR SIDE GUARDS - T-ARMS
REPLACING THE LOCKING
LEVER - T-ARMS (FIGURE 9)
1. Remove the T-arm from the wheelchair. Refer to
INSTALLING/REMOVING THE T-ARMS in this
procedure of the manual.
2. Remove the phillips bolt and locknut that secure
the existing locking lever to the bottom bracket.
NOTE: The locking lever is spring loaded. Place your
free hand over the locking lever to prevent the parts
from springing off of the bottom bracket.
Bottom
Bracket
Locking
Lever
Spring
Extended Ends
Locknut
Notch
Phillips Bolt
FIGURE 9 - REPLACING THE LOCKING
LEVER - T-ARMS
PROCEDURE 4
ARMS
A
R
M
S
Bottom
Socket
Screws
Bottom Clamp
Transfer
Assist
Side
Guard
T-arm
Socket
Screws
Exploded
for Clarity,
Do Not
Remove