Filter
Top Products
24
FRAMEPROCEDURE 3
F
R
A
M
E
This Procedure includes the following:
Folding/Unfolding Back - Folding Back
Wheelchairs Only
Adjusting Back Height
Adjusting Rear Seat Height
Adjusting Back Angle - Folding Back
Wheelchairs Only
WARNING
After adjustments and BEFORE use, make
sure all attaching hardware is securely
tightened, otherwise injury or damage
may occur.
FIGURE 2 - ADJUSTING BACK HEIGHT
Back Cane
HOLE NUMBER
5
4
3
2
1
ADJUSTING BACK HEIGHT
(FIGURE 2)
Back Canes Without Push Handles
NOTE: Observe the tautness of the back upholstery
for reinstallation.
1. If necessary, remove the back upholstery from the
wheelchair. Refer to BACK UPHOLSTERY in
PROCEDURE 2 of this manual.
WARNING
The push pin of the back cane insert
bar MUST be protruding through hole in
back cane.
Ensure that both back cane insert bars
are at same height BEFORE reassembling
the wheelchair.
2. Press the push pin on the back cane insert bar in
and reposition the back cane to one (1) of five (5)
height adjustment holes:
Original Back Height (in inches)
J HOLE # 8-11 10-14 12-16 14-18 16-20
1 810121416
2 911131517
3 10 12 14 16 18
4 11 13 15 17 19
5 N/A 14 16 18 20
J Holes numbered from bottom to top for reference
only. (There are no numbers on the back canes.)
3. Repeat STEP 2 for the opposite back cane.
NOTE: Make sure the two (2) back cane insert bars
are at the same height.
4. If necessary, reinstall the back upholstery. Refer
to BACK UPHOLSTERY in PROCEDURE 2 of
this manual.
FOLDING/UNFOLDING BACK -
FOLDING BACK WHEELCHAIRS
ONLY (FIGURE 1)
WARNING
Back MUST be locked securely in place
before using the wheelchair.
1. Perform one (1) of the following:
FOLDING - Pull up on the black nylon cord
and push the back forward to-
wards the front of the wheelchair.
UNFOLDING - Lift up on the back and pull to-
wards the rear of the wheelchair
until it locks into place.
FIGURE 1 - FOLDING/UNFOLDING BACK -
FOLDING BACK WHEELCHAIRS ONLY
Back Cane
Seat Frame
Rear of the
Wheelchair
Nylon Cord
Back Cane
Allen Screw
Locknut
DETAIL "A"