Filter
Top Products
40
Battery Cable
Battery Terminal
Cap
SECTION E - INSTALLING TERMINAL CAPS (FIGURE 8)
NOTE: Refer to INSTALLATION WARNINGS and CAUTIONS in the SAFETY SUMMARY of this instruction sheet.
1. Install battery terminal cap(s) onto battery cable(s) as follows:
A. ORANGE battery terminal cap onto RED battery cable extending from box top.
B. GRAY battery terminal cap onto BLACK battery cable extending from box top.
C. ORANGE battery terminal cap onto BLACK or WHITE battery (jumper) cable.
D. GRAY battery terminal cap onto BLACK or WHITE battery (jumper) cable.
FIGURE 8 - INSTALLING TERMINAL CAPS
SECTION F - CONNECTING BATTERY CABLE(S) TO BATTERY(IES)
(FIGURE 9)
1. Connect battery cable(s) to battery(ies) terminal(s)/post(s) as shown in FIGURE 9.
CAUTION
When connecting the battery cables to the battery(ies), the battery cable(s) MUST be connected to
the battery terminal(s)/post(s) as shown in FIGURE 9 (below), otherwise damage to the battery cable(s)
may result when sliding battery terminal cap(s) down onto battery terminal/posts.
When tightening the clamps, ALWAYS use a box wrench. Pliers will “round off” the nuts. NEVER wiggle
the battery terminal(s)/post(s) when tightening. The battery may become damaged.
The POSITIVE (+) RED battery cable MUST connect to the POSITIVE (+) battery terminal/post, otherwise
serious damage will occur to the electrical system.
2. Use one (1) 1/4-20 x 7/8-inch hex flange screw and one (1) 1/4-20 hex flange locknut to secure the battery cables
to the battery terminals/posts. Securely tighten. (FIGURE 7)
Connect battery
cable(s) ring terminal(s) to
this side of battery
terminal(s)/post(s)
+
-
-
1/4-20
Hex
Flange
Locknut
Battery Terminal/
Post
1/4-20 x 7/8-Inch
Hex Flange Screw
Battery
Terminal/Post
U1
Battery
Battery Cable
FIGURE 9 - CONNECTING BATTERY CABLE(S) TO BATTERY(IES)
B
A
T
T
E
R
I
E
S
PROCEDURE 6
BATTERIES