Filter
Top Products
29
This Procedure includes the following:
Installing/Removing Battery Tray
Installing/Removing Batteries from/into Single
Battery Box and Optional Dual Battery Boxes
Removing/Installing Battery Box(es)
When to Charge the Batteries
Charging the Batteries
WARNING
During use and charging, unsealed batteries will
vent hydrogen gas which is explosive in the right
concentration with air.
INSTALLING/REMOVING BATTERY
TRAY (FIGURE 1)
1. Remove the battery tray from the packaged container.
Crossbrace
Bolt Bushing
Battery Tray
Key Slot
Bracket
Hex Screws (Shown in 16-inch
Wheelchair Width position)
18-inch
Wheelchair
Width Position
Locknut
Locknut
B
A
T
T
E
R
I
E
S
PROCEDURE 6BATTERIES
Battery Tray
Hanger
Bracket
Support Tube
FIGURE 1 - INSTALLING/REMOVING BATTERY TRAY
NOTE: The hex screws will be positioned in the correct mount-
ing holes for the corresponding width of the wheelchair.
2. Secure the hanger brackets to the battery tray in the
mounting holes that the hex screws are mounted into.
3. Attach the key slot bracket located at the front of the
battery tray over the crossbrace bolt bushing under
the seat upholstery of the wheelchair.
4. Attach the hanger brackets to the support tubes on
the wheelchair frame.
NOTE: To remove the battery tray from the wheelchair,
reverse the above procedure.