Filter
Top Products
37
Initial Installation of Batteries into Battery Box
A. Remove dual battery boxes from wheelchair.
B. N/A
C. Installing battery into dual battery box
D. N/A
E. Install Terminal Caps
F. Connect Battery Cables.
G. Secure terminal caps to battery terminals/
posts.
H. Install battery box into wheelchair.
Removing/Installating the Batteries into/from
Battery Box
A. Remove dual battery box from wheelchair.
D. Disconnecting Battery Cables.
B. Remove the batteries from the dual battery boxes
C. Install the batteries into the dual battery boxes.
F. Connecting Battery Cables.
G. Securing terminal caps to battery terminals/
posts.
H. Install dual battery box into wheelchair.
SUMMARY OF INSTALLATION FOR - OPTIONAL DUAL BATTERY BOX
1. Perform the sections indicated, in order, to properly remove and/or install the batteries:
B
A
T
T
E
R
I
E
S
PROCEDURE 6
BATTERIES
SECTION A - REMOVE DUAL
BATTERY BATTERY BOXES FROM
WHEELCHAIR (FIGURE 1)
1. Place wheelchair in a well ventilated area where work
can be performed without risking damage to carpeting
or floor covering.
2. Verify that the ON/OFF switch on the joystick is in the
OFF position.
3. Disconnect the battery cables of the dual battery boxes
from the battery connectors on the wheelchair frame.
4. Disconnect the battery box retaining strap clip.
5. Remove batteries from wheelchair.
FIGURE 1 - REMOVING BATTERIES FROM
BATTERY BOX
NOTE: Wheelchair Frame not shown for clarity.
Retaining Strap Clip Retaining
Strap
Battery Boxes
Battery
Connection
SECTION B - REMOVING THE
BATTERIES FROM THE DUAL
BATTERY BOXES (FIGURE 2)
WARNING
Always use a battery lifting strap when lifting a
battery. It is the most convenient method and
assures that the battery acid will not spill (wet cell
batteries). It also helps to prolong the life of the
battery.
NOTE: Refer to the battery manufacturer for the proper
lifting strap and/or battery tools for U1 battery removal/
installation.
1. Clean battery terminals. Refer to CLEANING BAT-
TERY TERMINALS in this section.
2. Secure battery lifting strap or battery tools to battery
and remove from battery box. Repeat for other bat-
tery.
NOTE: If there is battery acid in the bottom or on the sides
of the battery box or battery, apply baking soda to these
areas to neutralize the battery acid. Before reinstalling the
NEW or existing battery(ies), clean the baking soda from
the battery box(es) or battery(ies).