Filter
Top Products
25
A
R
M
S
PROCEDURE 3ARMS
3. Reposition the plastic snap on the opposite armrest.
Make sure the plastic snap is positioned between the
two (2) mounting holes on the armrest.
4. Reposition the armrest pads on the opposite side of
the wheelchair.
5. Position the armrest pads on the armrests and se-
curely tighten with the existing phillips screws
REPLACING CLOTHING GUARDS
(FIXED HEIGHT ARMS ONLY)
(FIGURE 3)
1. Remove the four (4) screws that secure the existing
clothing guard to the armrest assembly.
2. Replace the existing clothing guard with the new clothing
guard and securely tighten with the existing hardware.
Screws
Armrest
Assembly
Clothing
Guard
FIGURE 3 - REPLACING CLOTHING GUARDS
(FIXED HEIGHT ARMS ONLY)
FIGURE 2 - REPLACING/REPOSITIONING DESK/
FULL LENGTH ARMREST PAD/PLASTIC SNAP
Phillips Screws
Armrest
Assembly
Armrest Pad
Armrest Pad
Armrest
Assembly
Phillips Screws
Half Clamps
(Reference Only)
Plastic SnAap