Filter
Top Products
39
SECTION D - DISCONNECT BATTERY
CABLE(S) FROM BATTERY(IES)
WARNING
NEVER allow any of your tools and/or battery
cable(s) to contact BOTH battery terminal(s)/
post(s) at the same time. An electrical short may
occur and serious personal injury, damage to the
wheelchair and/or damage to surrounding prop-
erty may occur.
1 . Carefully lift up existing U1 battery box top to expose
the underlying battery cables.
2. Cut the tie-wraps that secure the orange and gray
caps to the battery terminals/posts. (DETAIL “B”in
FIGURE 3)
3. Slide the terminal caps up on the battery cable. (DE-
TAIL “C” in FIGURE 3)
Orange Battery
Terminal Cap
POSITIVE
(+) Battery
Terminal/
Post
U-1 Battery
Tie-
Wrap
Battery Cable
Battery Terminal
Cap
FIGURE 3 - REMOVING/INSTALLING THE
BATTERIES FROM/INTO DUAL BATTERY BOXES
Locknut
Negative (-) Battery
Terminal/Post
Mounting Screw
Positive (+) Battery
Terminal/Post
U1
Battery
Battery
Cable
FIGURE 4 - REMOVING BATTERY FROM DUAL
BATTERY BOXES
4. Disconnect battery cable(s) from the battery as follows:
A. Remove the hex screw and locknut that secures
the NEGATIVE (-) BLACK battery cable to
NEGATIVE (-) battery terminal/post.
B. Remove the hex screw and locknut that secures the
POSITIVE (+) RED battery cable to POSITIVE (+)
battery terminal/post.
5. Secure battery lifting strap and/or battery tools to battery
terminal(s)/post(s).
6. Remove the battery from the battery box bottom.
+
-
B
A
T
T
E
R
I
E
S
PROCEDURE 6BATTERIES