Filter
Top Products
33
POSITIVE (+)
Battery Terminal/
Post
POSITIVE (+) Black Battery
Cable from Box Top
NEGATIVE (-) Battery
Terminal/Post
NEGATIVE (-)
Red Battery
Cable from Box Top
Positive (+)
Battery Terminal/
Post
+
-
Front Battery
Rear
Battery
Jumper Cable
(Note: This cable may be either
Black or White in color)
Battery
Box Top
5. Disconnect the battery cable (jumper) terminal end
from POSITIVE (+) battery terminal/post of FRONT
battery. (DETAIL “D” in FIGURE 5)
6. Disconnect NEGATIVE (-) BLACK battery cable extend-
ing from battery box top from NEGATIVE (-) battery
terminal/post of FRONT battery. (DETAIL “E” in FIG-
URE 5)
7. Disconnect POSITIVE (+) RED battery cable extend-
ing from box top from POSITIVE (+) battery terminal/
post of REAR battery. (DETAIL “E” in FIGURE 5)
Negative (-)
Battery Terminal/
Post
FIGURE 5 - DISCONNECT BATTERY CABLE(S)
FROM BATTERY(IES)
SECTION D - DISCONNECT BATTERY
CABLE(S) FROM BATTERY(IES)
WARNING
NEVER allow any of your tools and/or battery
cable(s) to contact BOTH battery terminal(s)/
post(s) at the same time. An electrical short may
occur and serious personal injury, damage to the
wheelchair and/or damage to surrounding prop-
erty may occur.
1 . Carefully lift up existing U1 battery box top to expose
the underlying battery cables.
2. Cut the tie-wraps that secure the orange and gray
caps to the battery terminals/posts. (DETAIL “B”in
FIGURE 4)
3. Slide the terminal caps up on the battery cable. (DE-
TAIL “C” in FIGURE 4)
4. Disconnect the battery cable (jumper) terminal end
from NEGATIVE (-) battery terminal/post of REAR
battery. (DETAIL “D” in FIGURE 5)
Orange Battery
Terminal Cap
POSITIVE
(+) Battery
Terminal/
Post
U-1 Battery
Gray Battery
Terminal Cap
Tie-
Wrap
NEGATIVE (-) Battery
Terminal/Post
Tie-
Wrap
Battery Cable
Battery Terminal
Cap
DETAIL “B”
DETAIL “C”
FIGURE 4 - REMOVING/INSTALLING THE
BATTERIES FROM/INTO SINGLE BATTERY BOX
+
-
+
-
DETAIL “D”
Front
Battery
Rear
Battery
Battery
Box Top
DETAIL “E”
+
-
B
A
T
T
E
R
I
E
S
PROCEDURE 6
BATTERIES