Filter
Top Products
32
Molded Carrying
Strap or Hold
Down Flange
Battery
Molded Carrying
Strap or Hold
Down Flange
Battery Lifting Strap
FRONT AREA OF
BATTERY BOX
REAR AREA OF
BATTERY BOX
BATTERY
BOX TOP
SECTION C - INSTALLING THE
BATTERIES INTO THE SINGLE
BATTERY BOX (FIGURE 3)
NOTE: Refer to the battery manufacturer for the proper
lifting strap and/or battery tools for U1 battery removal/
installation.
WARNING
U1 batteries in a single battery box MUST be posi-
tioned in the battery box as shown in FIGURE 1 for
proper battery cable connection to battery box
top.
Always use a battery lifting strap when lifting a
battery. It is the most convenient method and
assures that the battery acid will not spill (wet cell
batteries). It also helps to prolong the life of the
battery.
Some battery manufacturers mold a carrying
strap and/or hold down flanges directly into the
battery case. Batteries which interfere with the
battery box cannot be used for the these appli-
cations. Attempting to “wedge” a battery into a
battery box may damage the box and/or the
battery. Refer to DETAIL “A” in FIGURE 3.
l
l
This side faces the front
of the wheelchair
This side faces the rear of
the wheelchair
+-
FIGURE 3 - REMOVING/INSTALLING THE
BATTERIES FROM/INTO SINGLE BATTERY BOX
DETAIL “A”
1 . Secure battery lifting strap or battery tools to one (1)
battery and place battery in front area of battery box.
2 . Secure battery lifting strap or battery tools to remain-
ing battery and place battery in rear area of battery
box.
+-
B
A
T
T
E
R
I
E
S
PROCEDURE 6 BATTERIES