Filter
Top Products
Solara™ 72 Part No. 1080556 Rev. I
TRANSPORT READY OPTION
TRANSPORT READY OPTION
PROCEDURE 12
COMPLIANCE INFORMATION
This wheelchair conforms with the requirements of the ANSI/RESNA WC/Vol.1 - Section
19.5.3 (Frontal Impact Test).
NOTE: ANSI = American National Standards Institute
RESNA= Rehabilitation Engineering and Assistive Technology Society of North America
SPECIFICATIONS
Only wheelchairs which fit in the following size ranges should be occupied in a motor vehicle:
• 12-inches to 22-inches wide
• 15-inches to 22-inches deep
SECURING THE WHEELCHAIR TO THE VEHICLE
POSITIONING THE WHEELCHAIR IN THE VEHICLE
WARNING
This wheelchair must be in a forward facing position during travel in a motor vehicle.
Ensure quick-release pins are engaged through bearing housings and tilt slides.
The recommended clear zones for wheelchair seated occupants restrained by BOTH
pelvic and upper torso belt(s) and ONLY by a pelvic belt are shown in the diagrams
on the next page.
WARNINGS (CONTINUED)
Frontal Clear Zones (FCZ) need to be
LARGER when upper torso belt(s) are
NOT used.
The rear clear zone of 16-inches is
measured from the rearmost point
on an occupant’s head. The frontal
clear zone is measured from the
frontmost point on an occupant’s
head.
HHT is the estimated seated height from
the wheelchair ground plane to the top
of the wheelchair-seated occupant’s
head.
HHTs range from about 47-inches for a
small adult female, to about 61-inches for
a tall adult male.
FCZ = 26-inches with pelvic and upper-
torso belt(s), and 37-inches with ONLY a
pelvic belt.
The frontal clear zone may not be
achievable for wheelchair-seated drivers.
SIDE VIEW
HHT
(Frontal Clear Zone)
FCZ
TOP VIEW
8in.
8in.
FCZ
(Frontal Clear
Zone)
16in.
16in.
TRANSPORT READY OPTION