Filter
Top Products
Part No. 1080556 Rev. I 67 Solara™
CONTRACTURE ASSEMBLY ANGLE ADJUSTMENT
(FIGURE 4)
1. Perform one (1) of the following:
A. BILATERAL CONTRACTURE - Remove the mounting screw and locknut used
to lock the angle adjustment of the contracture assembly.
B. CONTRACTURE PLATFORM - Remove the two (2) hex screws and locknuts
that lock the angle adjustment of the contracture assembly.
2. Lift the contracture support UP/DOWN to achieve the desired angle.
3. Perform one (1) of the following:
A. BILATERAL CONTRACTURE - Align the mounting hole in the contracture
support with one (1) of seven (7) mounting holes on the angle adjustment bracket.
B. CONTRACTURE PLATFORM - Align the upper support mounting hole with
one (1) of four (4) mounting holes in the angle adjustment plate.
4. Reinstall the mounting screw(s) and locknut(s) to lock the angle adjustment of the
contracture assembly. Securely tighten.
FIGURE 4- CONTRACTURE ASSEMBLY ANGLE ADJUSTMENT
USING THE OPTIONAL QUICK-RELEASE PIN (FIGURE 5)
NOTE: This procedure applies to the bilateral contracture footplate only.
NOTE: The quick-release pin replaces the mounting screw that is used to lock the angle adjustment of
the contracture support.
WARNING
If not installed at time of shipment, the
quick-release pin MUST be installed by
a qualified technician only, using a 1/8-
inch pop rivet.
1. Press the button on the quick-release pin
and insert through the contracture sup-
port and the angle adjustment bracket.
2. If necessary adjust the angle of the
contracture assembly. Refer to
CONTRACTURE ASSEMBLY ANGLE
ADJUSTMENT in this procedure of the manual.
CONTRACTURE
FOOTPLATE OPTION
CONTRACTURE FOOTPLATE
OPTION
PROCEDURE 11
CONTRACTURE FOOTPLATE OPTION
BILATERAL CONTRACTURE
CONTRACTURE PLATFORM
Angle
Adjustment
Bracket
Mounting
Holes
Locknut
Contracture Support
Mounting
Screw
Hex
Screw
Upper
Support
Locknuts
Angle
Adjustment Plate
HOLE #
4
3
2
1
ANGLE
FIGURE 5 - USING THE OPTIONAL
QUICK-RELEASE PIN
Pop
Rivet
Quick-Release Pin
Angle Adjustment
Bracket
Contracture
Support
Button