Filter
Top Products
Part No. 1080556 Rev. I 11 Solara™
STABILITY - RECLINER MODELS ONLY
STABILITY WARNING
Before using ANY recline position of this wheelchair, make sure the rear wheels are in
the MOST REARWARD position in the axle mounting plate to maintain the stability
of the wheelchair. DO NOT change the handling/maneuverability of the wheelchair
by moving the rear wheels to ANY of the forward positions. Moving the rear wheels to
ANY of the forward positions WILL change the center of gravity of the wheelchair,
making the wheelchair less stable.
ALWAYS make sure that the wheelchair is stable both in the FULL RECLINED (back
at 180°) position AND the FULL UPRIGHT (back at 90°) position BEFORE using the
recliner option.
BEFORE using the recliner option, make sure the anti-tipper wheel assemblies are in
the lowest adjustment hole (adjustment hole closest to the ground/floor).
ALWAYS engage both wheel locks while reclining or inclining (reverse recline) the
wheelchair.
Both gas cylinders MUST be operational and adjusted properly BEFORE using the
recliner. DO NOT operate the recliner option if only one (1) of the gas cylinders is
operational or adjusted properly.
Make sure the patient is properly positioned in the wheelchair before reclining or
inclining (reverse recline) to maintain maximum stability and safety.
When returning the occupant of the wheelchair to the full upright position, more
body strength will be required for approximately the last twenty (20) degrees of
incline (reverse recline). Make sure to use proper body mechanics (use your legs) or
seek assistance to avoid injury.
Always return the back to the upright position before lifting the wheelchair.
OPERATING INFORMATION
GENERAL WARNINGS
Unless otherwise noted, all service and adjustments should be performed while the
wheelchair is unoccupied.
To determine and establish your particular safety limits, practice bending, reaching
and transferring activities in the presence of a qualified healthcare professional BE-
FORE attempting active use of the wheelchair.
Always wear your seat/chest positioning strap. Inasmuch as the SEAT/CHEST POSI-
TIONING STRAP is an option on this wheelchair (you may order with or without the
seat/chest positioning strap), Invacare strongly recommends ordering the seat/chest
positioning strap as an additional safeguard for the wheelchair user.
Always check foam grips for looseness before using the wheelchair. If loose, contact a
qualified technician for instructions.
The necessary back angle (90°, 100°, 110°
or 120°) MUST be selected BEFORE reposi-
tioning the rear wheels forward.
DO NOT operate the tilt-in-space if the trigger release levers and cables are not
properly adjusted to ensure that the tilt-in-space is locked in place when engaged.
DO NOT TRAVERSE, CLIMB or GO DOWN ramps or slopes GREATER than 9°.
NEVER leave the occupied wheelchair unattended at any time, especially on an
incline.
DO NOT attempt to reach objects if you have to move forward in the seat.
GENERAL GUIDELINES
PROCEDURE 1
GENERAL GUIDELINES
GENERAL GUIDELINES