Filter
Top Products
Solara™ 22 Part No. 1080556 Rev. I
FRONT RIGGINGSPROCEDURE 4
This Procedure Includes the Following:
Installing/Removing
Swingaway Footrest
Adjusting Swingaway Footrest Height
Adjusting Adjustable Angle Flip-up Footplates
Composite/Articulating Footplate Heel Loop Replacement
Installing/Removing Elevating Legrest/Calfpad Assembly
Adjusting the Elevating Legrest/Calfpad Assembly
FIGURE 1 - INSTALLING/REMOVING
SWINGAWAY FOOTREST
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage may
occur.
INSTALLING/REMOVING SWINGAWAY FOOTREST
(FIGURE 1)
INSTALLING
1. Turn the footrest to the side (open footplate is perpendicular to the wheelchair).
2. Insert the footrest assembly mounting pin into the mounting tube of the wheelchair frame.
3. Rotate the footrest towards the inside of the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat STEPS 1-3 for the other footrest assembly.
5. If necessary, adjust the footrest height. Refer to
ADJUSTING SWINGAWAY FOOTREST
HEIGHT in this procedure of the manual.
REMOVING
1. Push the footrest release lever inward while rotating the footrest outward.
2. Lift the footrest assembly out of the mounting pin of the wheelchair frame.
3. Repeat STEPS 1-2 for opposite side, if necessary.
Footrest Release
Lever
Footrest
Assembly
Mounting
Tube
Wheelchair
Frame
Footplate
NOTE: Only 60° Front Rigging
shown for clarity. Others will attach
the same way.
Mounting Pin
FRONT RIGGINGS
FRONT RIGGINGS