Filter
Top Products
Solara™ 34 Part No. 1080556 Rev. I
INSTALLING/REMOVING T-ARMS (FIGURE 9)
INSTALLING T-ARMS
1. Position the T-arm over the T-arm
socket on the wheelchair frame.
NOTE: Make sure the locking lever is towards the
front of the wheelchair.
2. Slide T-arm into T-arm socket until the
locking lever is in the slot in the T-arm
socket and an audible "click" is heard.
3. Pull up on T-arm to make sure T-arm is
locked in place.
NOTE: If the T-arm does not slide in the T-arm socket
as desired, adjust the T-arm socket. Refer to
ADJUST-
ING THE T-ARMS in this procedure of the manual.
4. Adjust the T-arm for desired height, width
and depth, if necessary. Refer to
ADJUSTING
THE T-ARMS in this procedure of the
manual.
5. Repeat STEPS 1-4 for opposite side of
wheelchair.
REMOVING T-ARMS
1. Press in on the locking lever and lift the T-arm straight up and out of the T-arm socket.
NOTE: If the T-arm does not slide up and down in the T-arm socket as desired, adjust the T-arm socket.
Refer to
ADJUSTING THE T-ARMS in this procedure of the manual.
2. Repeat STEP 2 for opposite side of the wheelchair.
FULL LENGTH ARM PADS
FIGURE 8 - ARM PAD REPLACEMENT FOR CANTILEVER ARMS
Mounting Screws
Cantilever
Arm Tube
Cantilever
Arm Tube
DESK LENGTH ARM PADS
Cantilever
Slide Tube
Mounting Screws
ARM PAD REPLACEMENT FOR CANTILEVER ARMS
(FIGURE 8)
1. Remove the mounting screws from the armrest pad.
2. Replace with NEW armrest pad.
3. Secure with existing hardware.
Armrest Pad
Arm Pad
ARMS
T-Arm
Socket
Locking Lever
(towards the front
of the wheelchair)
T-Arm
Wheelchair
Frame
FIGURE 9 - INSTALLING/
REMOVING T- ARMS
Slot
PROCEDURE 5 ARMS
ARMS