Filter
Top Products
Solara™ 20 Part No. 1080556 Rev. I
TROUBLESHOOTING
Chair Chair Sluggish Squeaks
Veers Veers Turn or Caster and Looseness
Right Left Performance Flutter Rattles in Chair SOLUTIONS
XX X
Check tires for correct
and equal pressure.
XXXXCheck for loose nuts
and bolts.
XX X Check that both
casters
contact the
ground at the same time.
SAFETY INSPECTION
MAINTENANCE
MAINTENANCE SAFETY PRECAUTIONS
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attach-
ing hardware is tightened securely - otherwise injury or damage may result.
CAUTION
DO NOT over tighten hardware attaching to the frame. This could cause
damage to the frame tubing.
SUGGESTED MAINTENANCE PROCEDURES
1. Keep quick-release axles free of dirt and lint to ensure positive locking and proper opera-
tion. Refer to ADJUSTING THE QUICK-RELEASE AXLE in PROCEDURE 8 of this manual.
WARNING
DO NOT use WD-40
®
, 3-in-1 oil
®
, or other penetrating lubricants on quick-
release axles. Otherwise, binding and/or damage to the wheelchair may occur.
2. Clean quick-release axles once (1) a week with a Teflon
®
lubricant.
WARNING
DO NOT use the wheelchair unless it has the proper tire pressure (p.s.i.). DO
NOT overinflate the tires. Failure to follow these suggestions may cause the
tire to explode and cause bodily harm.
3. If tires are pneumatic, recommended tire pressures will be listed on the side wall of the tires.
4. Periodically adjust wheel locks in correlation to tire wear. Refer to
WHEEL LOCK AD-
JUSTMENT in PROCEDURE 9 of this manual.
5. Make sure that ALL bolts are tight before operating wheelchair.
CAUTION
As with any vehicle, the wheels and tires should be checked periodically for
cracks and wear, and should be replaced.
6. The wheels and tires should be checked periodically for cracks and wear, and should be replaced.
7. Keep tilt slides and roller bearings free of dirt and lint to ensure proper operation of the
tilt mechanism.
SAFETY INSPECTION
SAFETY INSPECTIONPROCEDURE 2