Filter
Top Products
Solara™ 30 Part No. 1080556 Rev. I
ADJUSTING LOCKING CANTILEVER ARM ANGLE
(FIGURE 4)
NOTE: This adjustment is recommended if the back angle has been changed.
1. Flip the cantilever arm up and out of the way.
2. Remove the locknut that secures the locking pin to the arm adjustment plate.
3. Refer to FIGURE 4 to determine the mounting hole in the arm adjustment plate that will
be used to correspond to the back angle.
4. Securely tighten the locking pin and washer to the adjustment plate with a locknut.
5. Repeat STEPS 1-4 for the opposite side, if necessary.
FIGURE 3 - INSTALLING LOCKING CANTILEVER ARMS /
ADJUSTING LOCKING CANTILEVER ARM HEIGHT
Locknuts
Spacer
Actuator
Washers
Top Hex Bolt
and Coved Washer
Bottom Hex Bolt
Adjustment Plate
Back Cane
Coved Washers
Cantilever Arm
ARMS
PROCEDURE 5 ARMS