Filter
Top Products
Part No. 1080556 Rev. I 59 Solara™
FIGURE 3 - REPLACING THE RECLINER CABLES
Locknut
DETAIL "A"
Recline
Trigger
Release
Lever
Cable
Locking Nut
Recliner
Cable
Cable
Locking
Collar
Fitting
Cable
Locking
Nut
Actuator Housing
Tie
Wraps
Mounting
Screw
Back
Cane
DETAIL "C"
Adjustable Angle
Stroller Handle
Trigger
Release
Lever
Operating
RIGHT Gas
Cylinder
Trigger
Release
Lever
Operating
LEFT Gas
Cylinder
Tie
Wrap
Here
Recline
Cable
“X” Pattern
DETAIL "B"
Recliner
Cable
RECLINER BACK OPTION
7. Install the end of the recliner cable onto the actuator (DETAIL “B”).
NOTE: Make sure the recliner cable is positioned in the slot in the actuator.
8. Secure the recline cables to the back canes using NEW tie wraps (DETAIL “C”).
9. Repeat
REMOVING EXISTING RECLINER CABLES and INSTALLING NEW RECLINER
CABLES for the opposite recliner cable, if necessary.
10. Test the operation of the gas cylinders. Refer to
ADJUSTING THE GAS CYLINDERS in
this section of the manual.
RECLINER BACK OPTION
PROCEDURE 10
RECLINER BACK OPTION