Filter
Top Products
Solara™ 32 Part No. 1080556 Rev. I
PROCEDURE 5 ARMS
USING/INSTALLING/ADJUSTING NON-LOCKING
CANTILEVER ARMS
WARNING
DO NOT use lap trays with non-locking cantilever arms.
USING NON-LOCKING CANTILEVER ARMS (FIGURE 5)
1. Pull the end of the cantilever arm down
to lower the cantilever arm.
2. Pull the end of the cantilever arm up to
move it out of the way.
INSTALLING NON-LOCKING CANTILEVER ARMS (FIGURE 6)
1. Remove the locknut and washer from the lower hex bolt installed on the non-locking
cantilever arm.
2. Slide the hex bolt of the cantilever arm assembly into the desired mounting hole on the
back cane.
3. Secure the cantilever arm to the wheelchair with a washer and locknut as shown in
FIGURE 6.
4. Adjust the angle of the cantilever arm, if necessary. Refer to
ADJUSTING NON-LOCK-
ING CANTILEVER ARM ANGLE in this section of the manual.
ADJUSTING NON-LOCKING
CANTILEVER ARM HEIGHT
(FIGURE 6)
1. Remove the locknut and washer from
the lower hex bolt securing the cantile-
ver arm to the back cane.
2. Slide the cantilever arm assembly out of
the back cane.
3. Reposition the cantilever arm assembly
to the desired mounting hole.
4. Secure the cantilever arm to the wheel-
chair with a washer and locknut as
shown in FIGURE 6.
Back Cane
Cantilever Arm
REAR
FIGURE 5 - USING NON-LOCKING
CANTILEVER ARMS
Lower Hex Bolt
Locknut
Washer
Coved Washers
and Spacer
Cantilever Arm
FIGURE 6 - INSTALLING NON-
LOCKING CANTILEVER ARMS/
ADJUSTING NON-LOCKING
CANTILEVER ARM HEIGHT
Back Cane
ARMS
ARMS