Filter
Top Products
Quantum Scale System
Entering PLU Information 5 - 6
Typical On Screen Library Screen
On Screen Library - Auto
Look Up
Auto Look Up automatically looks up the product after a set
number of digits has been entered. It typically does not
require you to press ENTER. The characteristics of Auto
Look Up (i.e., On/Off, Number of Digits) are configured
during Scale Setup by your Supervisor.
If your Supervisor has selected 4-digit Auto Look Up, then
you must PRESS [ENTER] when entering a 1, 2, or 3-digit
PLU.
☛ Note
If you need to temporarily change product information,
such as tray size or tare, refer to Chapter Seven: Temporary
Override of Product Information later in this manual.